Proudcts
Product Name:ADC-FTTH-06
Details
ITEM Technical Parameters
Applicable for φ0.25mm&0.90mm Fiber
Optical fiber diameter 125μm(652A&657B)
Tight buffer diameter (μm) 250μm
Fiber mode Single & multi mode
Operation time About 10s(no fiber cut)
Aberage Insert loss

≤0.10dB(1310nm &1550nm)

Return loss ≤-40dB
Fastening strength of naked fiber >5N
Fastening strength of naked fiber holder >10N
Using temperature -45~+80℃
Repeatability(10 times) △IL≤0.2dB △RL≤5dB
 
操作说明
 
 
1.Laniate the FTTH flat cable to 50mm , and cut the jacket by scissors.   2.Insert the cable to the lead rail tool. as the photo position, and then strip the fiber at the end of tool.
 
3.To check if the fiber is damaged or not ,and then clean it by alcohol   4.Cut the fiber to 13mm.
 
5.Insert the fiber to the Mechanical splicer ,make the cable cut to the stop position of the Mechanical splicer   6.Make the fiber some bending to avoid damage when pull the cable. And then press the clamp at the end to fix the cable.
 
7.Prepare another FTTH flat cable, to insert it the same way as the above steps   8.When the cable cut at the stop position of Mechanical splicer , the fiber is bending , this mean it is correct way to install.
 
9.Press the clamp at both end to fix the cable. Make sure the fiber is bending.   10.Push the fixing button to the middle to fix it
   
11.Press the cover to the chasis ,and finish the whole installation.    
Other products:
ADC-FTTH-09
ADC-FTTH-08
ADC-FTTH-07
ADC-FTTH-05
ADC-FTTH-04
Close Window